Search results
Results from the WOW.Com Content Network
In static applications the exposure time can be as long as needed for an effective UV dose to be reached. In waterflow/airflow disinfection, exposure time can be increased by increasing the illuminated volume, decreasing the fluid speed, or recirculating the air or water repeatedly through the illuminated section.
The use of these agents should be considered in individuals exposed to doses above 1.5 Gy, should be given to those who develop fever and neutropenia and should be administered within 48 hours of exposure. An estimation of the exposure dose should be done by biological dosimetry whenever possible and by detailed history of exposure.
Exposure can be from a source of radiation external to the human body or due to internal irradiation caused by the ingestion of radioactive contamination. Ionizing radiation is widely used in industry and medicine, and can present a significant health hazard by causing microscopic damage to living tissue.
Ultraviolet radiation of wavelengths shorter than 300 nm (actinic rays) can damage the corneal epithelium. This is most commonly the result of exposure to the sun at high altitude, and in areas where shorter wavelengths are readily reflected from bright surfaces, such as snow, water, and sand.
Generally people can be exposed to radiation externally from radioactive material or internally by inhaling or ingesting radioactive substances. [11] Exposure to electromagnetic rays such as x-rays and gamma rays can, depending on the time exposed, cause sterility, genetic defects, premature ageing and death. [12]
Electron beams use an on-off technology and provide a much higher dosing rate than gamma or X-rays. Due to the higher dose rate, less exposure time is needed and thereby any potential degradation to polymers is reduced. Because electrons carry a charge, electron beams are less penetrating than both gamma and X-rays. Facilities rely on ...
This may result in infections, due to a low number of white blood cells, bleeding, due to a lack of platelets, and anemia, due to too few red blood cells in circulation. [3] These changes can be detected by blood tests after receiving a whole-body acute dose as low as 0.25 grays (25 rad ), though they might never be felt by the patient if the ...
Bioremediation of radioactive waste or bioremediation of radionuclides is an application of bioremediation based on the use of biological agents bacteria, plants and fungi (natural or genetically modified) to catalyze chemical reactions that allow the decontamination of sites affected by radionuclides. [1]