Search results
Results from the WOW.Com Content Network
Static random-access memory (static RAM or SRAM) is a type of random-access memory (RAM) that uses latching circuitry (flip-flop) to store each bit. SRAM is volatile memory; data is lost when power is removed. The static qualifier differentiates SRAM from dynamic random-access memory (DRAM):
Volatile memory is computer memory that requires power to maintain the stored information. Most modern semiconductor volatile memory is either static RAM (SRAM) or dynamic RAM (DRAM). [a] DRAM dominates for desktop system memory. SRAM is used for CPU cache. SRAM is also found in small embedded systems requiring little memory.
As this form of memory is less expensive to produce than static RAM, it is the predominant form of computer memory used in modern computers. Both static and dynamic RAM are considered volatile , as their state is lost or reset when power is removed from the system.
The memory cell is the fundamental building block of computer memory. The memory cell is an electronic circuit that stores one bit of binary information and it must be set to store a logic 1 ( high voltage level) and reset to store a logic 0 (low voltage level).
Quad Data Rate (QDR) SRAM is a type of static RAM computer memory that can transfer up to four words of data in each clock cycle. Like Double Data-Rate (DDR) SDRAM, QDR SRAM transfers data on both rising and falling edges of the clock signal. The main purpose of this capability is to enable reads and writes to occur at high clock frequencies ...
The two main types of random-access memory (RAM) are static RAM (SRAM), which uses several transistors per memory cell, and dynamic RAM (DRAM), which uses a transistor and a MOS capacitor per cell. Non-volatile memory (such as EPROM, EEPROM and flash memory) uses floating-gate memory cells, which consist of a single floating-gate transistor per ...
Position-independent code can be executed at any memory address without modification. This differs from absolute code, [ 1 ] which must be loaded at a specific location to function correctly, [ 1 ] and load-time locatable (LTL) code, [ 1 ] in which a linker or program loader modifies a program before execution, so it can be run only from a ...
Dynamic random-access memory (dynamic RAM or DRAM) is a type of random-access semiconductor memory that stores each bit of data in a memory cell, usually consisting of a tiny capacitor and a transistor, both typically based on metal–oxide–semiconductor (MOS) technology. While most DRAM memory cell designs use a capacitor and transistor ...