Search results
Results from the WOW.Com Content Network
Its GMC counterpart was the GMC New Design. It was billed as a larger, stronger, and sleeker design in comparison to the earlier AK Series . First available on Saturday, June 28, 1947, these trucks were sold with various minor changes over the years [ 3 ] until March 25, 1955, when the Task Force Series trucks replaced the Advance-Design model.
While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found ...
On 1 ⁄ 2-ton and 3 ⁄ 4-ton trucks, Chevrolet equipped a live rear axle with two coil-sprung trailing arms; along with auxiliary rear leaf springs, a rear leaf-spring suspension was an option. [6] GMC pickup trucks of the same payload series offered rear leaf springs as standard, with rear coil springs as optional equipment (the opposite of ...
GM created the model PD-4102 by restyling its PD-4101 in 1950 using a distinctive new front end with the destination sign below the windshield and a new, restyled rear end which used a full-width engine access door, an aluminum alloy bumper to match that on the front and a "post-less" picture window in the rear which used biradial curved glass ...
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints . The Dana 70 axle only came with 5.13:1, 4.88,5.31 [ citation needed ] gear ratios and had a GAWR of [ citation needed ] these axles were rated at 7-9klbs as seen on 5500 door ...
The GMC straight-6 engine was a series of gasoline-powered straight-six engines introduced in the 1939 model year by the GMC Trucks division of General Motors. Prior to the introduction of this new engine design GMC trucks had been powered by straight-six engines designed by the Buick , Pontiac and Oldsmobile divisions of GM.
6500 lbs (full float, rear axle) 5500 lbs (semi float) GAWR is vehicle axle weight plus rated payload capacity; Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35
The entire engine air intake and the axle system was fully vented to allow for operation while submerged under water. Its full-floating front axle was supported by the wheel hub, rather than the axle itself, and provided greater load capacity. The rear axle was semi-floating. Its drivetrain was the L-head 134.2 cu in (2.2 L) with a T-90 ...