Search results
Results from the WOW.Com Content Network
PCI Express x1 card with one RS-232 port on a nine-pin connector. In the book PC 97 Hardware Design Guide, [9] Microsoft deprecated support for the RS-232 compatible serial port of the original IBM PC design. Today, RS-232 has mostly been replaced in personal computers by USB for local communications. Advantages compared to RS-232 are that USB ...
The serial DCD pin can be used to accurately detect a PPS signal, as described in RFC 2783: [1] One convenient means to provide a PPS signal to a computer system is to connect that signal to a modem-control pin on a serial-line interface to the computer. The Data Carrier Detect (DCD) pin is frequently used for this purpose.
The only connector specified in the original RS-232 standard was the 25-pin D-subminiature, however, many other connectors have been used to save money or save on physical space, among other reasons. In particular, since many devices do not use all of the 20 signals that are defined by the standard, connectors with fewer pins are often used.
What links here; Upload file; Special pages; Printable version; Page information; Get shortened URL; Download QR code
RS-422 is a common transport mechanism for RS-232 extenders. These consist of RS-232 ports on either end of an RS-422 connection. Before hard-disk-based playout and editing systems were used, broadcast automation systems and post-production linear editing facilities used RS-422A [ check spelling ] to remotely control the players/recorders ...
A null modem adapter. Null modem is a communication method to directly connect two DTEs (computer, terminal, printer, etc.) using an RS-232 serial cable.The name stems from the historical use of RS-232 cables to connect two teleprinter devices or two modems in order to communicate with one another; null modem communication refers to using a crossed-over RS-232 cable to connect the teleprinters ...
In this diagram, one byte is sent, consisting of a start bit, followed by eight data bits (D1-8), and two stop bits, for a 11-bit UART frame. The number of data and formatting bits, the presence or absence of a parity bit, the form of parity (even or odd) and the transmission speed must be pre-agreed by the communicating parties.
The DTR signal is present on pin 20 of the 22-wire RS-232 interface using a DB-25 connector, and on pin 4 of a newer DE-9 serial port. The signal is asserted (logic "1") by raising the voltage of the pin from negative to positive. Dropping the signal back to its negative state indicates to the modem that the communications session shall be ...