Search results
Results from the WOW.Com Content Network
It may be used to power a remote control receiver so that when infrared or radio-frequency signals are sent by a remote control device, the equipment can respond, typically by changing from standby to fully on mode. Standby power may be used to power a display, operate a clock, etc., without switching the equipment to full power.
Timing light, combination instrument with RPM, volt meter and dwell angle meter. The actual light is on the far end. The black clamp connects to the battery -, the red clamp to +, the green one to the breaker side of the coil (for RPM), the big black clamp in the foreground is an inductive pick-up that clamps around a spark plug wire.
This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series. There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart.
Button, coin, or watch cells. A button cell, watch battery, or coin battery is a small battery made of a single electrochemical cell and shaped as a squat cylinder typically 5 to 25 mm (0.197 to 0.984 in) in diameter and 1 to 6 mm (0.039 to 0.236 in) high – resembling a button.
Dimmer light switch with RF-based remote control [1] A wireless light switch is a light switch that commands a light or home appliance to turn itself off or on, instead of interrupting the power line going to the light fixture. There are different ways to communicate between the switch and the fixture: [2]
Telechron—now the "Clock and Timer Division" of GE—declined in the 1950s, mainly because batteries had become much more long-lived and reliable. Battery-powered clocks have the obvious advantage of not depending on the proximity of a power outlet, and do not require the often somewhat unattractive electric cable.
This pin connects an external battery to the RTC (real-time clock) inside the microcontroller (R7FA4M1AB) to keep clock running when board is powered down. Connect this pin to positive side of 1.6 to 3.6 volt battery and negative side of battery to ground header pin (GND), such as a 3 volt lithium coin battery. [17] Remote-Off header pin (OFF).
Light output from LED flashlights varies even more widely than for incandescent lights. "Keychain" type lamps operating on button batteries, or lights using a single 5 mm LED, may only produce a few lumens. Even a small LED flashlight operating on an AA cell, but equipped with an LED, can emit 100 lumens.