Search results
Results from the WOW.Com Content Network
The tunnel, which was opened to traffic on 3 November 1955, is 8.93 kilometres (5.55 mi) long. It was the longest tunnel in New Zealand, superseding the Otira Tunnel in the South Island until the completion of the Kaimai Tunnel 9.03 kilometres (5.61 mi) near Tauranga in 1978. Remutaka remains the longest tunnel in New Zealand with scheduled ...
The Remutaka Rail Trail (spelled Rimutaka Rail Trail prior to 2017) is a walking and cycling track in the North Island of New Zealand.It runs between Maymorn and Cross Creek, and follows 22 kilometres (14 mi) of the original route of the Wairarapa Line over the Remutaka Range between the Mangaroa Valley and the Wairarapa, including the world-famous Rimutaka Incline.
Kaimai – 8879 m – opened 12 September 1978 – near Apata on the East Coast Main Trunk railway line to Tauranga, the longest rail tunnel in New Zealand. Rimutaka – 8798 m – opened 3 November 1955 – between Upper Hutt (Wellington) and Featherston , replaced the Rimutaka Incline, a Fell mountain railway, the longest tunnel in New ...
It opened on 12 August 1878 and closed on 30 October 1955, when it was replaced by the Rimutaka Tunnel. The former route is now the popular Remutaka Rail Trail and part of the Remutaka Cycle Trail. [6] The Rimutaka Incline Railway Heritage Trust has plans to rebuild the railway from Maymorn, including the Incline, as a tourist and historical ...
The Rimutaka Incline was a 3-mile-long (4.8 km), 3 ft 6 in (1,067 mm) gauge railway line on an average grade of 1-in-15 using the Fell system between Summit and Cross Creek stations on the Wairarapa side of the original Wairarapa Line in the Wairarapa district of New Zealand.
The ground on which the station is located was created using fill extracted during the construction of the Rimutaka Tunnel. During construction of the tunnel, a crossing loop long enough to accommodate 116 wagons and a temporary connection to the now closed section of the Wairarapa Line were built to enable work trains to bring in materials and ...
Once the yard had taken shape, work started on the tunnel, which was originally known as Rimutaka Tunnel. It was to be approached through a cutting six chains long and up to 60 feet deep. The line started out at a gradient of 1 in 1,000 on entering the tunnel for 12 chains, 1 in 300 for 11 chains, then got progressively steeper at 1 in 92, 44 ...
The Rimutaka Tunnel is a radio dead-spot, and the train driver and guard found the Train Control telephones on the tunnel wall to be dead. Shortly afterwards, the tunnel alarm sounded at Upper Hutt signal box indicating the train had been in the tunnel for more than 15 minutes, and a full-scale emergency response was activated.