Search results
Results from the WOW.Com Content Network
Properties of concrete. Concrete has relatively high compressive strength (resistance to breaking when squeezed), but significantly lower tensile strength (resistance to breaking when pulled apart). The compressive strength is typically controlled with the ratio of water to cement when forming the concrete, and tensile strength is increased by ...
The formation of fissures in the concrete cover above the reinforcement bars represents a preferential pathway for the ingress of water and aggressive agents such as CO 2 (lowering of pH around the rebar) and chloride anions (pitting corrosion) into concrete. The physical formation of cracks therefore favors the chemical degradation of concrete ...
The original cube (1 m sides) has a surface area to volume ratio of 6:1. The larger (2 m sides) cube has a surface area to volume ratio of (24/8) 3:1. As the dimensions increase, the volume will continue to grow faster than the surface area. Thus the square–cube law. This principle applies to all solids. [3]
A single concrete block, as used for construction. Concrete is a composite material composed of aggregate bonded together with a fluid cement that cures to a solid over time. . Concrete is the second-most-used substance in the world after water, [1] and is the most widely used building material
Prestressed beam without load. Prestressed beam with load. Prestressed concrete is a form of concrete used in construction. It is substantially "prestressed" (compressed) during production, in a manner that strengthens it against tensile forces which will exist when in service. [1][2]: 3–5 [3] It was patented by Eugène Freyssinet in 1928.
Water balance. Groundwater recharge or deep drainage or deep percolation is a hydrologic process, where water moves downward from surface water to groundwater. Recharge is the primary method through which water enters an aquifer. This process usually occurs in the vadose zone below plant roots and is often expressed as a flux to the water table ...
Creep and shrinkage of concrete are two physical properties of concrete. The creep of concrete, which originates from the calcium silicate hydrates (C-S-H) in the hardened Portland cement paste (which is the binder of mineral aggregates), is fundamentally different from the creep of metals and polymers. Unlike the creep of metals, it occurs at ...
The surface-area-to-volume ratio or surface-to-volume ratio (denoted as SA:V, SA/V, or sa/vol) is the ratio between surface area and volume of an object or collection of objects. SA:V is an important concept in science and engineering. It is used to explain the relation between structure and function in processes occurring through the surface ...