Search results
Results from the WOW.Com Content Network
A thermal interface material (shortened to TIM) is any material that is inserted between two components in order to enhance the thermal coupling between them. [1] A common use is heat dissipation, in which the TIM is inserted between a heat-producing device (e.g. an integrated circuit) and a heat-dissipating device (e.g. a heat sink).
Thermal paste is an example of a thermal interface material. As opposed to thermal adhesive , thermal paste does not add mechanical strength to the bond between heat source and heat sink. It has to be coupled with a fastener such as screws to hold the heat sink in place and to apply pressure, spreading and thinning the thermal paste.
Thermal adhesive is a type of thermally conductive glue used for electronic components and heat sinks. It can be available as a paste (similar to thermal paste) or as a double-sided tape. [1] It is commonly used to bond integrated circuits to heatsinks where there are no other mounting mechanisms available.
Housewrap is installed between the sheathing and the exterior siding, and is used behind vinyl, wood clapboards, shingles or shakes, brick, and other building materials. In all cases, the housewrap helps prevent water intrusion when moisture in any form gets past the siding and its trim and caulking.
Thicker grades of vinyl siding may, according to some, exhibit more resistance to the most common complaint about vinyl siding – its tendency to crack in very cold weather when it is struck or bumped by a hard object while others feel that a thinner product may allow more 'flex before cracking' and is a subject of debate. However, at "This ...
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
The core material may be polyethylene (which is combustible), a mineral-based material, or a combination of both. Panels of the same appearance may have different core materials; those with a higher proportion of mineral core withstand fire better, but can still be considered combustible. Fire will be spread by the cladding if the core is ...
This is accomplished by using a material that enables the easy removal of favorable interactions at the adhesive-backing or adhesive-adhesive interface, or by making both surfaces immiscible in one another. Two common materials used in polyacrylate-based adhesive tapes are fluorosilicones [9] and vinyl carbamates. [6]