enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RML 2.5-inch mountain gun - Wikipedia

   en.wikipedia.org/wiki/RML_2.5-inch_Mountain_Gun

   Writers who refer to "7-pounders" in World War I are in fact referring to this 2.5-inch (64 mm) gun. Romania bought 36 of these guns in 1883–1884, being designated in the local military nomenclature as "63 mm Armstrong mountain guns model 1883". They were the first guns designed for mountain warfare in Romanian use.

3. MythBusters (2011 season) - Wikipedia

   en.wikipedia.org/wiki/MythBusters_(2011_season)

   None of their shots turned the merry-go-round more than a fraction of an inch, but they did punch holes through the rails. A 12-gauge shotgun loaded with deer slugs gave the same result. The team added steel plates to the rails in an attempt to stop the bullets and force them to transfer their energy to the merry-go-round.

4. Belt (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Belt_(mechanical)

   An automotive belt with the number "740K6" or "6K740" indicates a belt 74 inches (190 cm) in length, 6 ribs wide, with a rib pitch of 9 ⁄ 64 of an inch (3.6 mm) (a standard thickness for a K series automotive belt would be 4.5mm). A metric equivalent would be usually indicated by "6PK1880" whereby 6 refers to the number of ribs, PK refers to ...

5. M1911 pistol - Wikipedia

   en.wikipedia.org/wiki/M1911_pistol

   From 1943 to 1945 a fine-grade russet-leather M1916 pistol belt set was issued to some generals in the U.S. Army. It was composed of a leather belt, leather enclosed flap-holster with braided leather tie-down leg strap, leather two-pocket magazine pouch, and a rope lanyard. The metal buckle and fittings were in gilded brass.

6. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   The broad end of the pin is slightly wider than the hole of the nail-header: the smith fits the pin into the hole of the nail-header and then hammers the broad end of the pin. Unable to advance through the hole, the broad end is flattened against the nail-header to create a nail-head.

7. Punched tape - Wikipedia

   en.wikipedia.org/wiki/Punched_tape

   Tape for punching was usually 0.00394 inches (0.100 mm) thick. The two most common widths were 11 ⁄ 16 inch (17 mm) for five bit codes, and 1 inch (25 mm) for tapes with six or more bits. Hole spacing was 0.1 inches (2.5 mm) in both directions. Data holes were 0.072 inches (1.8 mm) in diameter; sprocket feed holes were 0.046 inches (1.2 mm). [8]