enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Threaded rod - Wikipedia

   en.wikipedia.org/wiki/Threaded_rod

   A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...

3. Swivel - Wikipedia

   en.wikipedia.org/wiki/Swivel

   A common design for a swivel is a cylindrical rod that can turn freely within a support structure. The rod is usually prevented from slipping out by a nut, washer or thickening of the rod. The device can be attached to the ends of the rod or the center. Another common design is a sphere that is able to rotate within a support structure.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   This fitting (also known as a "bungalow fitting" or a "cottage fitting") is a sanitary tee that allows two trap arms to be connected at the same level. A toilet is the main connection, with the option of a right or left-hand outlet to the 3" inlet with a choice of 1-1/2" or 2" in size.

5. Turnbuckle - Wikipedia

   en.wikipedia.org/wiki/Turnbuckle

   A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.

6. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   There are two main types of clevis pins: threaded and unthreaded. Unthreaded clevis pins have a domed head at one end and a cross-hole at the other end. A cotter pin (US usage) or split pin is used to keep the clevis pin in place. Threaded clevis pins have a partially threaded shank on one end and a formed head on the other.

7. Threaded pipe - Wikipedia

   en.wikipedia.org/wiki/Threaded_pipe

   Therefore many municipal plumbing codes restrict the use of threaded plastic pipe fittings. Both British standard and National pipe thread standards specify a thread taper of 1:16; the change in diameter is one sixteenth the distance travelled along the thread. The nominal diameter is achieved some small distance (the "gauge length") from the ...