Search results
Results from the WOW.Com Content Network
There are mechanisms in place to ensure that the CE marking is put on products correctly. Controlling products bearing CE marking is the responsibility of public authorities in member states, in cooperation with the European Commission. Citizens may contact national market surveillance authorities if the misuse of the CE marking is suspected or ...
As clarified in the Medical Devices Directive — Directive 93/42/EEC [4] — it is required that alongside the CE mark all products must also have an Authorised Representative. As stated in this amendment, an Authorised Representative should serve as a contact point with the EU member states competent authorities.
The CE mark found on the back of many electronic devices does not mean that the product has obtained type approval in the European Union. The CE mark is the manufacturer's declaration that the system/assembly meets the minimum safety requirements of all the directives (laws) applicable to it, and of itself, does not signify any third party ...
Regulation No. 305/2011 [1] (Construction Products Regulation, or CPR) of the European Parliament and of the Council of the European Union is a regulation of 9 March 2011 which lays down harmonised conditions for the marketing of construction products and replaces Construction Products Directive (89/106/EEC).
CE Mark. A notified body, in the European Union, is an organisation that has been designated by a member state to assess the conformity of certain products, before being placed on the EU market, with the applicable essential technical requirements. These essential requirements are publicised in European directives or regulations.
CE Marking of construction products was introduced in the CPD in 1989. CE Marking is a declaration by the manufacturer that the product meets certain public safety requirements. The public safety requirements are a set of essential characteristics that each product must satisfy and these characteristics are given in the product's harmonised ...
The Low Voltage Directive (LVD) 2006/95/EC is one of the oldest Single Market Directives adopted by the European Union before the "New" or "Global" Approach. [1] The Directive provides common broad objectives for safety regulations, so that electrical equipment approved by any EU member country will be acceptable for use in all other EU countries.
All new machinery should carry a CE mark, [3] UKCA marking from its manufacturer to prove its compliance with safety laws. When a CE mark is not relevant then responsibility of the equipment’s safety and up keeping can fall to the organisation.