Search results
Results from the WOW.Com Content Network
The pivoting design allows the outboard motor to be swiveled by the operator in almost all directions: Sideways for direction, up and down to change the thrust line according to speed or bow lift, elevate completely out of water for easy starting, placing the drive shaft and the propeller forward along the side of the boat for reverse, or put ...
The device is different from the Voith-Schneider marine propulsion system (also mechanically linked), which can also quickly change the direction of thrust, as the Z-drive uses a shrouded conventional screw that pivots or rotates the propeller, unlike the variable-geometry blades of the Voith-Schneider.
Subsidiaries include Mercury Precision Parts and Accessories as well as Mercury propellers and Mercury Jet Drives. Mercury outboards 30 hp and below are manufactured by Tohatsu in Japan. [citation needed] Mercury developed a processor-enhanced line of outboards called the "Verado" outboard engine.
Modular propellers may be fitted to aircraft as well as boats. [1] The benefits of a modular propeller are that its specifications (such as blade pitch or propeller diameter) may be altered to suit varying conditions; and it becomes much easier to replace damaged elements, such as a broken blade. Traditional one-piece propellers may be ...
A ducted propeller, also known as a Kort nozzle, is a marine propeller fitted with a non-rotating nozzle. It is used to improve the efficiency of the propeller and is especially used on heavily loaded propellers or propellers with limited diameter. It was developed first by Luigi Stipa (1931) and later by Ludwig Kort (1934). The Kort nozzle is ...
Marine propellers are also known as "screws". There are many variations of marine screw systems, including twin, contra-rotating, controllable-pitch, and nozzle-style screws. While smaller vessels tend to have a single screw, even very large ships such as tankers, container ships and bulk carriers may have single screws for reasons of fuel ...
A marine thruster consists of a propeller or impeller which may be encased in some kind of tunnel or ducting that directs the flow of water to produce a resultant force intended to obtain movement in the desired direction or resist forces which would cause unwanted movement.
A chopper is a propeller design largely of interest for production outboards on fast pad v-bottom boats. Unlike a cleaver the chopper's trailing edge extends aft with a large chord line at each radius.