enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Duodecimal - Wikipedia

    en.wikipedia.org/wiki/Duodecimal

    The duodecimal system, also known as base twelve or dozenal, is a positional numeral system using twelve as its base.In duodecimal, the number twelve is denoted "10", meaning 1 twelve and 0 units; in the decimal system, this number is instead written as "12" meaning 1 ten and 2 units, and the string "10" means ten.

  3. Ancient Greek units of measurement - Wikipedia

    en.wikipedia.org/wiki/Ancient_Greek_units_of...

    12: 4 ⁄ 9: 25: 1 ... Modern equivalent Description pous ... Athenians measured the day by sundials and unit fractions.

  4. List of unusual units of measurement - Wikipedia

    en.wikipedia.org/wiki/List_of_unusual_units_of...

    A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...

  5. Inch - Wikipedia

    en.wikipedia.org/wiki/Inch

    Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as ⁠2 + 3 / 8 ⁠ ″ and not as 2.375″ nor as ⁠2 + 6 / 16 ⁠ ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...

  6. Fraction - Wikipedia

    en.wikipedia.org/wiki/Fraction

    Unit fractions can also be expressed using negative exponents, as in 21, which represents 1/2, and 22, which represents 1/(2 2) or 1/4. A dyadic fraction is a common fraction in which the denominator is a power of two, e.g. ⁠ 1 / 8 ⁠ = ⁠ 1 / 2 3 ⁠. In Unicode, precomposed fraction characters are in the Number Forms block.

  7. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    Example (metric fine): For M7.0×0.5, major minus pitch yields 6.5, which at 92.9% happens to be an example that pushes over the outer bound of the 90% ± 2 pp, but major minus pitch is still valid, although smaller drills (6.3 mm, 14, 6.4 mm) will work well.

  8. Unit fraction - Wikipedia

    en.wikipedia.org/wiki/Unit_fraction

    Slices of approximately 1/8 of a pizza. A unit fraction is a positive fraction with one as its numerator, 1/ n.It is the multiplicative inverse (reciprocal) of the denominator of the fraction, which must be a positive natural number.

  9. Irreducible fraction - Wikipedia

    en.wikipedia.org/wiki/Irreducible_fraction

    Two fractions ⁠ a / b ⁠ and ⁠ c / d ⁠ are equal or equivalent if and only if ad = bc.) For example, ⁠ 1 / 4 ⁠, ⁠ 5 / 6 ⁠, and ⁠ −101 / 100 ⁠ are all irreducible fractions. On the other hand, ⁠ 2 / 4 ⁠ is reducible since it is equal in value to ⁠ 1 / 2 ⁠, and the numerator of ⁠ 1 / 2 ⁠ is less than the numerator ...