Search results
Results from the WOW.Com Content Network
Two-inch port tube installed in the top of a Polk S10 speaker cabinet as part of a DIY audio project. This port is flared. Unlike closed-box loudspeakers, which are nearly airtight, a bass reflex system has an opening called a port or vent cut into the cabinet, generally consisting of a pipe or duct (typically circular or rectangular cross section).
These designs can be considered a mass-loaded transmission line design or a bass reflex design, as well as a quarter wave enclosure. [39] Quarter wave resonators have seen a revival as commercial applications with the onset of neodymium drivers that enable this design to produce relatively low bass extensions within a relatively small speaker ...
A common use of Thiele/Small parameters is in designing PA system and hi-fi speaker enclosures; the TSP calculations indicate to the speaker design professionals how large a speaker cabinet will need to be and how large and long the bass reflex port (if it is used) should be.
This article lists manufacturers of bass amplifiers, loudspeakers, and other amplification-related items such as preamplifiers. The amplifiers and loudspeakers used to amplify bass instruments (e.g., the bass guitar, double bass and similar instruments) are distinct from other types of amplification systems due to the particular challenges associated with low-frequency sound reproduction.
Passive radiators are used instead of a reflex port for several reasons. In small-volume enclosures tuned to low frequencies, the length of the required port becomes very large. [5] They are also used to reduce or eliminate the objectionable noises of port turbulence and compressive flow caused by high-velocity airflow in small ports.
Moving iron speaker. The original loudspeaker design was the moving iron. Unlike the newer dynamic (moving coil) design, a moving-iron speaker uses a stationary coil to vibrate a magnetized piece of metal (called the iron, reed, or armature). The metal is either attached to the diaphragm or is the diaphragm itself.
IMF electronics were the only company manufacturing the transmission line speakers. The name IMF was adopted because Bud Fried had demonstrated the first prototype speakers at the New York hi fi show, and because of the publicity and the fact that he had used his name on the then unnamed speakers, we stuck with the name which was a mistake on ...
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.