Search results
Results from the WOW.Com Content Network
Injector pens remove some of the complications of syringes by allowing the pen to be "pushed" against the skin at a 90-degree angle (removing the need to inject at a proper angle as is the case with syringes), as well as by replacing a long, thin plunger of a syringe with a simple button which is depressed and held to inject the dose. [2]
A syringe is a simple reciprocating pump consisting of a plunger (though in modern syringes, it is actually a piston) that fits tightly within a cylindrical tube called a barrel. The plunger can be linearly pulled and pushed along the inside of the tube, allowing the syringe to take in and expel liquid or gas through a discharge orifice at the ...
The insulin syringe was the first syringe that is considered low dead space. It was initially created with low dead space for accurate measuring and mixing of fast and slow acting insulin, which had the added benefit of wasting as little of the expensive drug as possible.
A syringe with a male luer lock fitting, and a needle with female luer lock fitting (purple) which screws into it. The Luer taper is a standardized system of small-scale fluid fittings used for making leak-free connections between a male-taper fitting and its mating female part on medical and laboratory instruments, including hypodermic syringe tips and needles or stopcocks and needles.
Alexander Wood's main contribution was the all-glass syringe in 1851, which allowed the user to estimate dosage based on the levels of liquid observed through the glass. [12] Wood used hypodermic needles and syringes primarily for the application of localized, subcutaneous injection (localized anesthesia) and therefore was not as interested in ...
Auto Disable (AD) syringes are designed as a single use syringe, with an internal mechanism blocking the barrel once depressed so it cannot be depressed again. The other type of syringe with a re-use prevention feature is the breaking plunger syringe. An internal mechanism cracks the syringe when the plunger is fully depressed to prevent ...
A gas syringe has an inner syringe chamber which has a ground glass surface. The syringe barrel also has a ground glass surface. The ground surface of the barrel moves freely within the ground glass surface of the syringe chamber with very little friction. The close mating of these ground glass surfaces also gives a reasonably gas-tight seal. [3]
This connector attaches to another device: e.g. syringe, vacuum tube holder/hub, or extension tubing from an infusion pump or gravity-fed infusion/transfusion bag/bottle. Newer models include a slide and lock safety device slid over the needle after use, which helps prevent accidental needlestick injury and reuse of used needles, which can ...