Search results
Results from the WOW.Com Content Network
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
A Winegard 68 element VHF/UHF aerial antenna. This common multi-band antenna type uses a UHF Yagi at the front and a VHF log-periodic at the back coupled together. When a higher-gain antenna is needed to achieve adequate reception in suburban or fringe reception areas, an outdoor directional antenna is usually used.
Amplifier and loudspeaker with two elements and crossover networks. Top: normal connection. Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two ...
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
It usually consists of a single wire or network of horizontal wires, parallel to the ground, suspended above the ground under the antenna, connected to the receiver or transmitter's "ground" wire. [2] The counterpoise functions as one plate of a large capacitor, with the conductive layers of the earth acting as the other plate. [2] [3]
The G5RV antenna is a dipole antenna fed indirectly, through a carefully chosen length of 300 Ω or 450 Ω twin lead, which acts as an impedance matching network to connect (through a balun) to a standard 50 Ω coaxial transmission line. The sloper antenna is a slanted vertical dipole antenna attached to the top of a single tower. The element ...
A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...
An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude (magnitude of the voltage or current) of a signal applied to its input ...