Search results
Results from the WOW.Com Content Network
Clock signal and legend. In electronics and especially synchronous digital circuits, a clock signal (historically also known as logic beat) [1] is an electronic logic signal (voltage or current) which oscillates between a high and a low state at a constant frequency and is used like a metronome to synchronize actions of digital circuits.
A clock generator is an electronic oscillator that produces a clock signal for use in synchronizing a circuit's operation. The output clock signal can range from a simple symmetrical square wave to more complex arrangements. The basic parts that all clock generators share are a resonant circuit and an amplifier.
Slave clocks come in many shapes and sizes. They can connect to the master clock through either a cable or a short-range wireless signal. In the 19th century Paris used a series of pneumatic tubes to transmit the signal. [1] Some slave clocks will run independently if they lose the master signal, often with a warning light lit.
In digital electronics, a synchronous circuit is a digital circuit in which the changes in the state of memory elements are synchronized by a clock signal. In a sequential digital logic circuit, data is stored in memory devices called flip-flops or latches. The output of a flip-flop is constant until a pulse is applied to its "clock" input ...
The MDF is a termination point within the local telephone exchange where exchange equipment and terminations of local loops are connected by jumper wires at the MDF. All cable copper pairs supplying services through user telephone lines are terminated at the MDF and distributed through the MDF to equipment within the local exchange e.g. repeaters and DSLAM.
In broadcast engineering, a distribution frame is a location within an apparatus room through which all signals (audio, video, or data) pass, with the ability to arbitrarily route and connect sources and destinations between studios and other internal and external points. Connections can either be soldered, or made using terminal blocks.
Items that should remain consistent are TTL level, a 75ohm output impedance, 75ohm cables and a 75ohm terminating resistor at the end of a chain or cable. Proper termination of the word clock signal with a 75ohm resistor is important. It prevents the clock signal from reflecting back into the cable and causing false detection of extra 1's and 0's.
The transmit clock signal is always provided by the MAC on the TXC line. The receive clock signal is always provided by the PHY on the RXC line. [citation needed] Source-synchronous clocking is used: the clock signal that is output (by either the PHY or the MAC) is synchronous with the data signals. This requires the PCB to be designed to add a ...