Search results
Results from the WOW.Com Content Network
It is especially popular as a unit of measurement with shooters familiar with the imperial measurement system because 1 MOA subtends a circle with a diameter of 1.047 inches (which is often rounded to just 1 inch) at 100 yards (2.66 cm at 91 m or 2.908 cm at 100 m), a traditional distance on American target ranges.
The final value of the hardness depends on the depth of the indenter after it has been applied for 15 seconds on the material. If the indenter penetrates 2.54 mm (0.100 inch) or more into the material, the durometer is 0 for that scale. If it does not penetrate at all, then the durometer is 100 for that scale.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Thus, a 1U rackmount computer is not 1.750 inches (44.5 mm) tall but is 1.719 inches (43.7 mm) tall. If n is number of rack units, the ideal formula for panel height is h = 1.75n − 0.031 for calculating in inches, and h = 44.45n − 0.794 for calculating in millimeters. This gap allows a bit of room above and below an installed piece of ...
The progression of thicknesses is clear in column 3 (U.S. standard for sheet and plate iron and steel 64ths inch (delta)). The thicknesses vary first by 1 ⁄ 32 inch in higher thicknesses and then step down to increments of 1 ⁄ 64 inch, then 1 ⁄ 128 inch, with the final increments at decimal fractions of 1 ⁄ 64 inch.
Billet mills, three-high, rolls from 24 to 32 inches in diameter, used for the further reduction of blooms down to 1.5x1.5-inch billets, being the nubpreparatory mills for the bar and rod Beam mills, three-high, rolls from 28 to 36 inches in diameter, for the production of heavy beams and channels 12 inches and over.
The diameter of the equivalent large format round shape is rounded to the nearest 1 ⁄ 8 inch to provide the bar size. For example, #9 bar has a cross section of 1.00 square inch (6.5 cm 2), and therefore a diameter of 1.128 inches (28.7 mm). #10, #11, #14, and #18 sizes correspond to 1 1 ⁄ 8 inch, 1 1 ⁄ 4, 1 1 ⁄ 2, and 2-inch square ...
For example, the so-called "1/1.8-inch" format with a 9 mm sensor diagonal has a crop factor of almost 5 relative to the 43.3 mm diagonal of 35 mm film. Therefore, these cameras are equipped with lenses that are about one-fifth of the focal lengths that would be typical on a 35 mm point-and-shoot film camera.