enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Kaiser Aluminum - Wikipedia

   en.wikipedia.org/wiki/Kaiser_Aluminum

   Kaiser Aluminum Corporation is an American aluminum producer. It is a spinoff from Kaiser Aluminum and Chemicals Corporation, which came to be when common stock was offered in Permanente Metals Corporation and Permanente Metals Corporation's name was changed to Kaiser Aluminum and Chemicals Corporation.

3. Extrusion - Wikipedia

   en.wikipedia.org/wiki/Extrusion

   A horizontal hydraulic press for hot aluminum extrusion (loose dies and scrap visible in foreground) There are many different variations of extrusion equipment. They vary by four major characteristics: [1] Movement of the extrusion with relation to the ram. If the die is held stationary and the ram moves towards it then it is called "direct ...

4. 6061 aluminium alloy - Wikipedia

   en.wikipedia.org/wiki/6061_aluminium_alloy

   6061 is an alloy used in the production of extrusions—long constant–cross-section structural shapes produced by pushing metal through a shaped die. Cold and Hot Stamping. 6061 sheet in the T4 condition can be formed with limited ductility in the cold state.

5. Semi-finished casting products - Wikipedia

   en.wikipedia.org/wiki/Semi-finished_casting_products

   A billet is a length of metal that has a round or square cross-section, with an area less than 36 in 2 (230 cm 2). Billets are created directly via continuous casting or extrusion or indirectly via hot rolling an ingot or bloom. [1] [2] [4] Billets are further processed via profile rolling and drawing. Final products include bar stock and wire. [3]

6. Mill finish - Wikipedia

   en.wikipedia.org/wiki/Mill_finish

   Mill finish is the surface texture (or finish) of metal after it exits a rolling mill, extrusion die, or drawing processes, including sheet, bar, plate, or structural shapes. This texture is usually rough and lacks lustre; it may have spots of oxidation or contamination with mill oil.

7. Hydroforming - Wikipedia

   en.wikipedia.org/wiki/Hydroforming

   Tools and punches can be interchanged for different part requirements. One advantage of hydroforming is the savings on tools. For sheet metal only a draw ring and punch (metalworking) or male die is required. Depending on the part being formed, the punch can be made from epoxy, rather than metal.