Ads
related to: datasheet resistor 10 ohmalldatasheet.com has been visited by 10K+ users in the past month
- Sensor(4,099)
Search Description : 'SENSOR'
Total: 8,074 (1/404) Pages
- Relay(4,287)
Search Description : 'RELAY'
Total: 1/516 Pages
- Capacitor(1,225)
Search Description : 'CAPACITOR'
Total: 7,514 (1/376) Pages
- Led(23,211)
Search Description : 'LED'
Total: 1/1,817 Pages
- Sensor(4,099)
Search results
Results from the WOW.Com Content Network
Carbon film resistors feature a power rating range of 0.125 W to 5 W at 70 °C. Resistances available range from 1 ohm to 10 megaohm. The carbon film resistor has an operating temperature range of −55 °C to 155 °C. It has 200 to 600 volts maximum working voltage range.
The reason for the name "ohms per square" is that a square sheet with sheet resistance 10 ohm/square has an actual resistance of 10 ohm, regardless of the size of the square. (For a square, =, so =.) The unit can be thought of as, loosely, "ohms · aspect ratio". Example: A 3-unit long by 1-unit wide (aspect ratio = 3) sheet made of material ...
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
As quoted in an online version of: David R. Lide (ed), CRC Handbook of Chemistry and Physics, 84th Edition.CRC Press. Boca Raton, Florida, 2003; Section 4, Properties of the Elements and Inorganic Compounds; Physical Properties of the Rare Earth Metals
This E series merging is noted on resistor datasheets and webpages as "E96 + E24" or "E192 + E24". [ 14 ] [ 15 ] [ 16 ] In the following table, the dashed E24 values don't exist in the E48, E96, or E192 series:
A standard TTL input at logic "1" is normally operated assuming a source current of 40 μA, and a voltage level above 2.4 V, allowing a pull-up resistor of no more than 50 kohms; whereas the TTL input at logic "0" will be expected to sink 1.6 mA at a voltage below 0.8 V, requiring a pull-down resistor less than 500 ohms. [3]
The physical origins of ESR depend on the device in question. One way to deal with these inherent resistances in circuit analysis is to use a lumped-element model to express each physical component as a combination of an ideal component and a small resistor in series, the ESR. The ESR can be measured and included in a component's datasheet. To ...
The word rheostat was coined in 1843 by Sir Charles Wheatstone, [7] from the Greek ῥέος rheos meaning "stream", and - στάτης-states (from ἱστάναι histanai, "to set, to cause to stand") meaning "setter, regulating device", [8] [9] [10] which is a two-terminal variable resistor. For low-power applications (less than about 1 ...
Ads
related to: datasheet resistor 10 ohmalldatasheet.com has been visited by 10K+ users in the past month