Search results
Results from the WOW.Com Content Network
To support these, a computer system is typically designed so that its watchdog timer will be kicked only if the computer deems the system functional. The computer determines whether the system is functional by conducting one or more fault detection tests and will kick the watchdog only if all tests have passed. [citation needed]
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
This is usually handled with a separate "automated fault-detection system". In the case of the tire, an air pressure monitor detects the loss of pressure and notifies the driver. The alternative is a "manual fault-detection system", such as manually inspecting all tires at each stop. Interference with fault detection in another component.
However, many problems only occur as a result of multiple failures or errors. This is particularly true of fault tolerant systems, or those with built-in redundancy. Features that add redundancy, fault detection and failover to a system may also be subject to failure, and enough different component failures in any system will "take it down."
Time-domain reflectometer for cable fault detection A time-domain reflectometer ( TDR ) is an electronic instrument used to determine the characteristics of electrical lines by observing reflected pulses .
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
Sometimes a timeshift (delay) is set between systems, which increases the detection probability of errors induced by external influences (e.g. voltage spikes, ionizing radiation, or in situ reverse engineering).
The construction of a failure detector is an essential, but a very difficult problem that occurred in the development of the fault-tolerant component in a distributed computer system. As a result, the failure detector was invented because of the need for detecting errors in the massive information transaction in distributed computing systems.