enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Three different international-standard two-hole punches. A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves).

3. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch and die themselves can have a variety of shapes to create an array of different shaped holes in the workpiece. Multiple punches may be used together to create a part in one step. Usually, the punch and die are close to the same dimensions, creating a sheared edge when they meet.

4. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

5. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   Typical distance from the paper edge to the center of the hole is 0.5 inches (13 mm), and typical diameter of the hole ranges from 0.25 inches (6.4 mm) to 0.31 inches (7.9 mm) in North American usage. Three ring binder sprung clip mechanism. Japan uses a unique system, referred to as J-Binder. This system is compatible with A4 and B5 paper with ...

6. Blanking and piercing - Wikipedia

   en.wikipedia.org/wiki/Blanking_and_piercing

   Punches are available in various shape and sizes; oblong and rectangular punches are common because they minimize waste and allow for greater distances between strokes, as compared to a round punch. Nibbling can occur on the exterior or interior of the material, however interior cuts require a hole to insert the tool. [5]

7. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.