Search results
Results from the WOW.Com Content Network
In direct extrusion the billet is pushed through the die with ram pressure, whereas in indirect extrusion a die moves relative to the container. Rule based analysis of extrusion process would help to determine a set of rules essential for consideration while designing a product, or even during cost estimation of a product.
Die swell is an expansion of the melt as the pressure is released, and is dependent on polymer chemistry and die design. After curing, the solid, continuous part is drawn onto a take-up roller or cut into transportable lengths, depending on the type of part. This process may vary significantly depending on the type of die and extrusion process. [1]
The direct spinning process avoids the stage of solid polymer pellets. The polymer melt is produced from the raw materials, and then from the polymer finisher directly pumped to the spinning mill. Direct spinning is mainly applied during production of polyester fibers and filaments and is dedicated to high production capacity (>100 ton/day).
Extrusion is a process used to create objects of a fixed cross-sectional profile by pushing material through a die of the desired cross-section. Its two main advantages over other manufacturing processes are its ability to create very complex cross-sections; and to work materials that are brittle, because the material encounters only ...
A simple cross-section schematic of the slot-die coating process. Slot-die coating is a coating technique for the application of solution, slurry, hot-melt, or extruded thin films onto typically flat substrates such as glass, metal, paper, fabric, plastic, or metal foils.
Extrusion profiles with holes are very difficult to produce because they can not be just produced by a simple die, so it should be practiced to reduce the number of holes as much as possible. With steels and other less extrudable materials, holes in asymmetrical shapes should be avoided because they lead to unsymmetrical stresses which cause ...
Plastics extrusion is a high-volume manufacturing process in which raw plastic is melted and formed into a continuous profile. Extrusion produces items such as pipe/tubing, weatherstripping , fencing, deck railings , window frames , plastic films and sheeting, thermoplastic coatings, and wire insulation.
Microextrusion is an outgrowth of microforming, a science that was in its infancy in the early 1990s. In 2002, Engel et al. expressed that up to that point, only a few research experiments involving micro-deep drawing and extruding processes had been attempted, citing limitations in shearing on billets and difficulties in tool manufacturing and handling. [1]