Search results
Results from the WOW.Com Content Network
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
The Taylor KO factor multiplies bullet mass (measured in grains) by muzzle velocity (measured in feet per second) by bullet diameter (measured in inches) and then divides the product by 7,000, converting the value from grains to pounds and giving a numerical value from 0 to ~150 for normal hunting cartridges.
Projectiles are described by a ballistic coefficient, or BC, which combines the air resistance of the bullet shape (the drag coefficient) and its sectional density (a function of mass and bullet diameter). The deceleration due to drag that a projectile with mass m, velocity v, and diameter d will experience is proportional to 1/BC, 1/m, v² and ...
For projectiles in unpowered flight, its velocity is highest at leaving the muzzle and drops off steadily because of air resistance.Projectiles traveling less than the speed of sound (about 340 m/s (1,100 ft/s) in dry air at sea level) are subsonic, while those traveling faster are supersonic and thus can travel a substantial distance and even hit a target before a nearby observer hears the ...
Bullet diameter.375 in (9.5 mm) Land diameter.366 in (9.3 mm) [1] ... The most commonly used bullet weights for the .375 Winchester are between 180 gr to 260 gr (11.7 ...
The balle D am ammunition was followed in 1932 by balle N ammunition, which featured a lead-cored, cupro-nickel-over-steel-jacketed, pointed boat-tail bullet weighing 15.0 g (232 grains). It was thicker (8.3 mm instead of 8.17) and was held into a case that had a slightly larger neck diameter than that for the older balle D am ammunition.
The limit to bore diameter is generally the sectional density of the projectile (see external ballistics). Larger-diameter bullets of the same weight have much more drag, and so they lose energy more quickly after exiting the barrel. In general, most handguns use bullets between .355 (9 mm) and .45 (11.5 mm) caliber, while most rifles generally ...
Bullet parts: 1 metal jacket, 2 lead core, 3 steel penetrator. Terminal ballistics is a sub-field of ballistics concerned with the behavior and effects of a projectile when it hits and transfers its energy to a target. Bullet design (as well as the velocity of impact) largely determines the effectiveness of penetration. [1]