enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   Not to be confused with Printed electronics. For other uses, see PCB (disambiguation). "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the ...

3. Printed circuit board milling - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board_milling

   A milled printed circuit board. Printed circuit board milling (also: isolation milling) is the milling process used for removing areas of copper from a sheet of printed circuit board (PCB) material to recreate the pads, signal traces and structures according to patterns from a digital circuit board plan known as a layout file. [1]

4. Point-to-point construction - Wikipedia

   en.wikipedia.org/wiki/Point-to-point_construction

   Section of a typical Australian late 1930s radio, showing the point to point construction between components. In electronics, point-to-point construction is a non-automated technique for constructing circuits which was widely used before the use of printed circuit boards (PCBs) and automated assembly gradually became widespread following their introduction in the 1950s.

5. Depaneling - Wikipedia

   en.wikipedia.org/wiki/Depaneling

   A depaneling router is a machine similar to wood router. It uses a router bit to mill the material of the PCB. The hardness of the PCB material wears down the bit, which must be replaced periodically. Routing requires that single boards are connected using tabs in a panel. The bit mills the whole material of the tab.

6. Routing (electronic design automation) - Wikipedia

   en.wikipedia.org/wiki/Routing_(electronic_design...

   In electronic design, wire routing, commonly called simply routing, is a step in the design of printed circuit boards (PCBs) and integrated circuits (ICs). It builds on a preceding step, called placement , which determines the location of each active element of an IC or component on a PCB.

7. Phenolic paper - Wikipedia

   en.wikipedia.org/wiki/Phenolic_paper

   The back of two circuit boards. The brown one is an FR-2 made of paper phenol. Phenolic paper is a material often used to make printed circuit board substrates (the flat board to which the components and traces are attached). It is a very tough board made of wood fibre and phenolic polymers. It is most commonly brown in colour, and is a fibre ...

8. Perfboard - Wikipedia

   en.wikipedia.org/wiki/Perfboard

   Software for PCB layout can often be used to generate perfboard layouts as well. In this case, the designer positions the components so all leads fall on intersections of a 0.1 inches (2.54 mm) grid. In this case, the designer positions the components so all leads fall on intersections of a 0.1 inches (2.54 mm) grid.

9. Chip on board - Wikipedia

   en.wikipedia.org/wiki/Chip_on_board

   The PCB of a quartz watch. The clock IC is under the drop of black epoxy. Chip on board (COB) is a method of circuit board manufacturing in which the integrated circuits (e.g. microprocessors) are attached (wired, bonded directly) to a printed circuit board, and covered by a blob of epoxy. [1]