enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 6061 aluminium alloy - Wikipedia

   en.wikipedia.org/wiki/6061_aluminium_alloy

   ASTM B221: Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes; ASTM B308/308M: Standard Specification for Aluminum-Alloy 6061-T6 Standard Structural Profiles; ASTM B483: Standard Specification for Aluminum and Aluminum-Alloy Drawn Tube and Pipe for General Purpose Applications

3. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.

4. List of brazing alloys - Wikipedia

   en.wikipedia.org/wiki/List_of_brazing_alloys

   When brazing cast iron, graphite must be removed from the surface to assure good wetting. May facilitate stress cracking of some alloys by liquid metal embrittlement; prior stress relief annealing is required then, or use of a higher melting point alloy that does not melt until stress relief temperature of the base metal is reached.

5. Aluminium joining - Wikipedia

   en.wikipedia.org/wiki/Aluminium_joining

   Aluminium alloys are often used due to their high strength-to-weight ratio, corrosion resistance, low cost, high thermal and electrical conductivity.There are a variety of techniques to join aluminium including mechanical fasteners, welding, adhesive bonding, brazing, soldering and friction stir welding (FSW), etc. Various techniques are used based on the cost and strength required for the joint.

6. Annealing (materials science) - Wikipedia

   en.wikipedia.org/wiki/Annealing_(materials_science)

   The high temperature of annealing may result in oxidation of the metal's surface, resulting in scale. If scale must be avoided, annealing is carried out in a special atmosphere, such as with endothermic gas (a mixture of carbon monoxide, hydrogen gas, and nitrogen gas). Annealing is also done in forming gas, a mixture of hydrogen and nitrogen.

7. Aluminium–magnesium–silicon alloys - Wikipedia

   en.wikipedia.org/wiki/Aluminium–magnesium...

   The AlMgSi alloys are therefore understood in the standards as a separate group (6000 series) and not as a subgroup of aluminum-magnesium alloys that cannot be hardenable. AlMgSi is one of the aluminum alloys with medium to high strength, high fracture resistance, good welding suitability, corrosion resistance and formability. They can be ...