enow.com Web Search

  1. Ads

    related to: control valve for propane burner

Search results

  1. Results from the WOW.Com Content Network
  2. Propane, butane, and LPG container valve connections

    en.wikipedia.org/wiki/Propane,_butane,_and_LPG...

    A DIN standard for gas cylinder valves for test pressures up to 300 bar (4,400 psi). EN 15202 [9] A European standard for LPG equipment and accessories, specifying LPG cylinder valve connections. [10] EN 417: European norm specification concerning non-refillable metallic cartridges for liquefied petroleum gases.

  3. Pressure regulator - Wikipedia

    en.wikipedia.org/wiki/Pressure_regulator

    The inlet pressure gauge will indicate this pressure. The gas then passes through the normally open pressure control valve orifice and the downstream pressure rises until the valve actuating diaphragm is deflected sufficiently to close the valve, preventing any more gas from entering the low pressure side until the pressure drops again.

  4. Gas stove - Wikipedia

    en.wikipedia.org/wiki/Gas_stove

    Mean benzene emissions from gas and propane burners on high and ovens set to 350 °F ranged from 2.8 to 6.5 μg min–1, 10 to 25 times higher than emissions from electric coil and radiant alternatives. [1] Some high-end cooktop models provide higher range of heat and heavy-duty burners that can go up to 6 kilowatts (20,000 BTU/h) or even more.

  5. Flame supervision device - Wikipedia

    en.wikipedia.org/wiki/Flame_supervision_device

    For gas appliances, a flame supervision device (FSD) – alternative name: flame failure device (FFD) – is a general term for any device designed to stop flammable gas going to the burner of a gas appliance if the flame is extinguished. This is to prevent a dangerous buildup of gas within the appliance, its chimney or the room. [1]

  6. POL valve - Wikipedia

    en.wikipedia.org/wiki/POL_valve

    POL is the common name for the standard CGA 510 (US Compressed Gas Association connection number). The Thread specification is .885" – 14 NGO – LH – INT, meaning 0.885 in (22.5 mm) diameter thread, 14 threads per inch (1.814 mm pitch), National Gas Outlet form, left-hand internal thread. [3]

  7. Control valve - Wikipedia

    en.wikipedia.org/wiki/Control_valve

    A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure , temperature , and liquid level.

  1. Ads

    related to: control valve for propane burner