enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flashing (weatherproofing) - Wikipedia

   en.wikipedia.org/wiki/Flashing_(weatherproofing)

   Roof penetration flashing Used to waterproof pipes, supports, cables, and all roof protrusions. Stainless steel penetration flashings have proven to be the longest lasting and most reliable roof flashing type. Channel flashing Shaped like a “U” or channel to catch water (e.g., where the edge of a tile roof meets a wall). Through wall flashing

3. Rain gutter - Wikipedia

   en.wikipedia.org/wiki/Rain_gutter

   A roof must be designed with a suitable fall to allow the rainwater to discharge. The water drains into a gutter that is fed into a downpipe. A flat roof should have a watertight surface with a minimum finished fall of 1 in 80. They can drain internally or to an eaves gutter, which has a minimum 1 in 360 fall towards the downpipe.

4. Flat roof - Wikipedia

   en.wikipedia.org/wiki/Flat_roof

   A flat roof is a roof which is almost level in contrast to the many types of sloped roofs. The slope of a roof is properly known as its pitch and flat roofs have up to approximately 10°. [1] Flat roofs are an ancient form mostly used in arid climates and allow the roof space to be used as a living space or a living roof. Flat roofs, or "low ...

5. List of roof shapes - Wikipedia

   en.wikipedia.org/wiki/List_of_roof_shapes

   Arched roof, bow roof, [11] Gothic, Gothic arch, and ship's bottom roof. Historically also called a compass roof. [12] [13] Circular Bell roof (bell-shaped, ogee, Philibert de l'Orme roof): A bell-shaped roof. Compare with bell-cast eaves. Domed; Onion dome or rather an imperial roof; Bochka roof; Conical roof or cone roof; Hyperbolic Saddle

6. Reglet - Wikipedia

   en.wikipedia.org/wiki/Reglet

   A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the surface, known as ...

7. Eaves - Wikipedia

   en.wikipedia.org/wiki/Eaves

   Eaves must be designed for local wind speeds as the overhang can significantly increase the wind loading on the roof. [7] The line on the ground under the outer edge of the eaves is the eavesdrip, or dripline, and in typical building planning regulations defines the extent of the building and cannot oversail the property boundary.