enow.com Web Search

  1. Ads

    related to: engine overheating water pump

Search results

  1. Results from the WOW.Com Content Network
  2. Internal combustion engine cooling - Wikipedia

    en.wikipedia.org/wiki/Internal_combustion_engine...

    The seal was inherited from steam engines, where water loss is accepted, since steam engines already expend large volumes of water. Because the pump seal leaked mainly when the pump was running and the engine was hot, the water loss evaporated inconspicuously, leaving at best a small rusty trace when the engine stopped and cooled, thereby not ...

  3. Radiator (engine cooling) - Wikipedia

    en.wikipedia.org/wiki/Radiator_(engine_cooling)

    Engine coolant is directed by the thermostat to the inlet of the circulating pump and is returned directly to the engine, bypassing the radiator. Directing water to circulate only through the engine allows the engine to reach optimum operating temperature as quickly as possible whilst avoiding localized "hot spots."

  4. Coolant pump - Wikipedia

    en.wikipedia.org/wiki/Coolant_pump

    A coolant pump is a type of pump used to recirculate a coolant, generally a liquid, that is used to transfer heat away from an engine or other device that generates heat as a byproduct of producing energy. Common applications of coolant pumps are:

  5. Applications of the Stirling engine - Wikipedia

    en.wikipedia.org/wiki/Applications_of_the...

    The Beta type engine weighed 360 grams, and produced only 20 watts of power. [18] The engine was attached to the front of a modified Super Malibu radio control glider with a gross takeoff weight of 1 kg. The best-published test flight lasted 6 minutes and exhibited "barely enough power to make the occasional gentle turn and maintain altitude". [18]

  6. Ford Model T engine - Wikipedia

    en.wikipedia.org/wiki/Ford_Model_T_engine

    Hot water, being less dense, would rise to the top of the engine and up into the top of the radiator, descending to the bottom as it cooled, and back into the engine. (This was the direction of water flow in most cars which did have water pumps, until the introduction of crossflow radiator designs.) The thermosiphon system was susceptible to ...

  7. Thermosiphon - Wikipedia

    en.wikipedia.org/wiki/Thermosiphon

    As engine power increased, increased flow of water was required, so engine-driven pumps were added to assist circulation. More compact engines began to use smaller radiators and require more convoluted flow patterns, so the water circulation became entirely dependent on the pump and might even be reversed against its natural direction.

  8. Yanmar 2GM20 - Wikipedia

    en.wikipedia.org/wiki/Yanmar_2GM20

    The engines equipped with a fresh water cooling system have an additional heat exchanger, where heat transfer occurs between the seawater and internal freshwater. The impeller of the seawater pump can suffer from wear and tear, especially when run dry for some period of time, in which case it has to be replaced to avoid loss in the flow of ...

  9. Ford flathead V8 engine - Wikipedia

    en.wikipedia.org/wiki/Ford_flathead_V8_engine

    The routing of the exhaust through the water jacket put an extremely heavy load on the cooling system and led to frequent overheating, especially on early models, if the cooling system was not maintained. Somewhat primitive water pumps used until the advent of the 1948 8RT and 1949 8BA models also contributed to the overheating problem.

  1. Ads

    related to: engine overheating water pump