Search results
Results from the WOW.Com Content Network
Due to typical file system design, the amount of space allocated for a file is usually larger than the size of the file's data – resulting in a relatively small amount of unusable storage space for each file, called slack space or internal fragmentation.
In this convention, one thousand and twenty-four megabytes (1024 MB) is equal to one gigabyte (1 GB), where 1 GB is 1024 3 bytes (i.e., 1 GiB). Mixed 1 MB = 1 024 000 bytes (= 1000×1024 B) is the definition used to describe the formatted capacity of the 1.44 MB 3.5-inch HD floppy disk, which actually has a capacity of 1 474 560 bytes. [5]
Memory bandwidth is the rate at which data can be read from or stored into a semiconductor memory by a processor.Memory bandwidth is usually expressed in units of bytes/second, though this can vary for systems with natural data sizes that are not a multiple of the commonly used 8-bit bytes.
These prefixes are more often used for multiples of bytes, as in kilobyte (1 kB = 8000 bit), megabyte (1 MB = 8 000 000 bit), and gigabyte (1 GB = 8 000 000 000 bit). However, for technical reasons, the capacities of computer memories and some storage units are often multiples of some large power of two, such as 2 28 = 268 435 456 bytes.
On the other hand, a hard disk whose capacity is specified by the manufacturer as "10 gigabytes" or "10 GB", holds 10 × 10 9 = 10 000 000 000 bytes, or a little more than that, but less than 10 × 2 30 = 10 737 418 240 and a file whose size is listed as "2.3 GB" may have a size closer to 2.3 × 2 30 ≈ 2 470 000 000 or to 2.3 × 10 9 = 2 300 ...
An alternative system of nomenclature for the same units (referred to here as the customary convention), in which 1 kilobyte (KB) is equal to 1,024 bytes, [38] [39] [40] 1 megabyte (MB) is equal to 1024 2 bytes and 1 gigabyte (GB) is equal to 1024 3 bytes is mentioned by a 1990s JEDEC standard. Only the first three multiples (up to GB) are ...
For example, the first commercial hard drive, IBM's RAMAC in 1957, supplied 3.75 MB for $34,500, or $9,200 per megabyte. In 1989, a 40 MB hard drive cost $1200, or $30/MB. And in 2018, 4 Tb drives sold for $75, or 1.9¢/GB, an improvement of 1.5 million since 1989 and 520 million since the RAMAC.
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...