enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. R-value (insulation) - Wikipedia

   en.wikipedia.org/wiki/R-value_(insulation)

   Installed faced fiberglass batt insulation with its R-value visible (R-21) [1]. The R-value is a measure of how well a two-dimensional barrier, such as a layer of insulation, a window or a complete wall or ceiling, resists the conductive [2] flow of heat, in the context of construction. [3]

3. List of insulation materials - Wikipedia

   en.wikipedia.org/wiki/List_of_insulation_materials

   This is a list of insulation materials used around the world. Typical R-values are given for various materials and structures as approximations based on the average of available figures and are sorted by lowest value. R-value at 1 m gives R-values normalised to a 1 metre (3 ft 3 in) thickness and sorts by median value of the range.

4. Vacuum insulated panel - Wikipedia

   en.wikipedia.org/wiki/Vacuum_insulated_panel

   This means that VIPs have about one-fifth the thermal conductivity of conventional insulation, and therefore about five times the thermal resistance per unit thickness. Based on a typical k-value of 0.007 W/(m·K), the R-value of a typical 25-millimetre-thick (1 in) VIP would be 3.5 m 2 ·K/W (20 h·ft 2 ·°F/BTU). To provide the same R-value ...

5. Building insulation - Wikipedia

   en.wikipedia.org/wiki/Building_insulation

   The effectiveness of bulk insulation is commonly evaluated by its R-value, of which there are two – metric (SI) (with unit K⋅W −1 ⋅m 2) and US customary (with unit °F⋅ft 2 ⋅h/BTU), the former being 0.176 times the latter numerically, or the reciprocal quantity the thermal conductivity or U-value W⋅K −1 ⋅m −2.

6. Building insulation material - Wikipedia

   en.wikipedia.org/wiki/Building_insulation_material

   Unscrupulous contractors may "fluff" insulation using fewer bags than optimal for a desired R-value. Dry-spray (but not wet-spray) cellulose can settle 20% of its original volume. [28] However, the expected settling is included in the stated R-Value. The dense-pack dry installation reduces settling and increases R-value.

7. Cellulose insulation - Wikipedia

   en.wikipedia.org/wiki/Cellulose_insulation

   The R-value of 3.6 to 3.8 per inch [citation needed] is good but not the best. [citation needed] Material cost per R-value is good but labor cost goes up because it takes more material and time to install than fiberglass insulation at the same R-Value [citation needed].