Ads
related to: wiring 8 ohm speakerscrutchfield.com has been visited by 100K+ users in the past month
- TVs
Shop Our Selection of 4K and LED
TVs, Projectors and Accessories
- Car Audio
All the Latest Gear from Stereos to
Backup Cams and Bluetooth Adapters
- GPS Navigation
Get GPS for Your Car, Truck, Boat,
Motorcycle, or Fitness Activities
- Home Theater
A/V Gear to Bring the Movie Theater
Experience into Your Living Room
- TVs
- 3579 S High St, Columbus, OH · Directions · (614) 409-0683
Search results
Results from the WOW.Com Content Network
[citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for lower rated impedances. Measured in henries (H), this is the inductance of the voice coil. The voice coil is a lossy inductor, in part due to losses in the pole piece, so the apparent inductance changes with frequency.
A horn-loaded speaker can have a sensitivity as high as 110 dB at 2.83 volts (1 watt at 8 ohms) at 1 meter. This is a hundredfold increase in output compared to a speaker rated at 90 dB sensitivity and is invaluable in applications where high sound levels are required or amplifier power is limited.
Connecting a low-impedance load such as a loudspeaker (usually 4 to 8 Ω) to a line out will essentially short circuit the output circuit. Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal ...
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
Ads
related to: wiring 8 ohm speakerscrutchfield.com has been visited by 100K+ users in the past month
- 3579 S High St, Columbus, OH · Directions · (614) 409-0683
