Search results
Results from the WOW.Com Content Network
A range of rugged hand-held scan tools is available. Simple fault code readers/reset tools are mostly aimed at the consumer level. Professional hand-held scan tools may possess more advanced functions Access more advanced diagnostics; Set manufacturer- or vehicle-specific ECU parameters; Access and control other control units, such as air bag ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
OBD 1 vs OBD 2 the vehicle will also dictate what the scan tool is able to display. If the vehicle is equipped with OBD 1 it will have significantly less available data when compared to a vehicle equipped with OBD 2. [2] When a vehicle detects a problem, it generates a DTC code which is a unique code that corresponds to the specific problem ...
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
Unlike generic on-board diagnostics (OBD-II or EOBD), VCDS uses the more in-depth Volkswagen Group-specific manufacturer protocol commands, [4] which allows the user to access all diagnostic capable vehicle systems — even in vehicles which are not covered by generic OBD-II/EOBD (e.g. pre-1996).
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
Early EEC-IV equipped cars don't have the capability to send sensor data through the diagnostic connector to a scan tool. However, there are KOEO (Key On, Engine Off) and KOER (Key On, Engine Running) self-tests, and a continuous-monitor (wiggle) test, a feature to help test the wiring connections to various sensors/actuators by wiggling the ...
A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.