Search results
Results from the WOW.Com Content Network
Different types of wood warping. Wood warping is a deviation from flatness in timber as a result of internal residual stress caused by uneven shrinkage. Warping primarily occurs due to uneven expansion or contraction caused by changes in moisture content.
In modern rammed earth buildings, the walls are constructed on top of conventional footings or a reinforced concrete slab base. Contemporary slip formwork in use. The construction of an entire wall begins with a temporary frame, the "formwork", which is usually made of wood or plywood, as a mold for each wall section's desired shape and dimensions.
Diaphragms are usually constructed of plywood or oriented strand board in timber construction; metal deck or composite metal deck in steel construction; or a concrete slab in concrete construction. [1] The two primary types of the diaphragm are flexible and rigid. [1]
A typical timber shear wall consists of braced panels in the wall line, constructed using structural plywood sheathing, specific nailing at the edges, and supporting framing. A shear wall is an element of a structurally engineered system that is designed to resist in- plane lateral forces, typically wind and seismic loads.
With the increased use of concrete as a subfloor in some parts of the world, engineered wood flooring has gained some popularity. However, solid wood floors are still common and popular, but are commonly more expensive in the United States and considered higher end.
Plates carry bending in two directions. A concrete flat slab is an example of a plate. Plates are understood by using continuum mechanics, but due to the complexity involved they are most often designed using a codified empirical approach, or computer analysis.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
On the dawn of the revival of concrete in slab structures, building techniques for the temporary structures were derived again from masonry and carpentry. The traditional slab formwork technique consists of supports out of lumber or young tree trunks, that support rows of stringers assembled roughly 3 to 6 feet or 1 to 2 metres apart, depending ...