enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. GU24 lamp fitting - Wikipedia

    en.wikipedia.org/wiki/GU24_lamp_fitting

    The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb. [2]

  3. Bi-pin lamp base - Wikipedia

    en.wikipedia.org/wiki/Bi-pin_lamp_base

    The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

  4. Wedge base - Wikipedia

    en.wikipedia.org/wiki/Wedge_base

    Some bulbs have no plastic base, and the wires are simply bent up to the sides of the bulb's glass base. The bulb is inserted and removed with straight in or out force, without turning as with a bayonet mount or Edison screw, on certain bi-pin light sockets. For true wedges, compression is the force that holds the bulb in, while others use ...

  5. Lightbulb socket - Wikipedia

    en.wikipedia.org/wiki/Lightbulb_socket

    G4 – 4 mm (0.15748 in) pin spacing GU4 & GZ4 – same as G4 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G5.3 – 5.3 mm (0.20866 in) pin spacing GU5.3, GX5.3, GY5.3, GZ5.3 – same as G5.3 and only denote what lamp mount clip is needed to hold the actual light bulb in place

  6. Electrical connector - Wikipedia

    en.wikipedia.org/wiki/Electrical_connector

    Pogo pin connectors. Pogo pin or spring loaded connectors are commonly used in consumer and industrial products, where mechanical resilience and ease of use are priorities. [32] The connector consists of a barrel, a spring, and a plunger. They are in applications such as the MagSafe connector where a quick disconnect is desired for safety.

  7. USB hardware - Wikipedia

    en.wikipedia.org/wiki/USB_hardware

    To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...

  8. American Travis Timmerman flown out of Syria after release ...

    www.aol.com/american-travis-timmerman-flown...

    A U.S. defense official told CBS News that Travis Timmerman was flown out of Syria and into Jordan by the U.S. military and handed over to the State Department.

  9. LED lamp - Wikipedia

    en.wikipedia.org/wiki/LED_lamp

    A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...