enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Galvanic cell - Wikipedia

    en.wikipedia.org/wiki/Galvanic_cell

    When a current flows in the circuit, equilibrium conditions are not achieved and the cell voltage will usually be reduced by various mechanisms, such as the development of overpotentials. [ 11 ] (§ 25.12 "Working galvanic cells") Also, since chemical reactions occur when the cell is producing power, the electrolyte concentrations change and ...

  3. Open-circuit voltage - Wikipedia

    en.wikipedia.org/wiki/Open-circuit_voltage

    The voltage v oc between the terminals is the open-circuit voltage of the device. Black curve: The highest possible open-circuit voltage of a solar cell in the Shockley-Queisser model under unconcentrated sunlight, as a function of the semiconductor bandgap. The red dotted line shows that this voltage is always smaller than the bandgap voltage.

  4. Open-circuit saturation curve - Wikipedia

    en.wikipedia.org/wiki/Open-circuit_saturation_curve

    The open-circuit saturation curve (also open-circuit characteristic, OCC) of a synchronous generator is a plot of the output open circuit voltage as a function of the excitation current or field. The curve is typically plotted alongside the synchronous impedance curve .

  5. Open-circuit test - Wikipedia

    en.wikipedia.org/wiki/Open-circuit_test

    The open-circuit test, or no-load test, is one of the methods used in electrical engineering to determine the no-load impedance in the excitation branch of a transformer. The no load is represented by the open circuit, which is represented on the right side of the figure as the "hole" or incomplete part of the circuit.

  6. Output impedance - Wikipedia

    en.wikipedia.org/wiki/Output_impedance

    The actual output impedance for most devices is not the same as the rated output impedance. A power amplifier may have a rated impedance of 8 ohms, but the actual output impedance will vary depending on circuit conditions. The rated output impedance is the impedance into which the amplifier can deliver its maximum amount of power without failing.

  7. Passive sign convention - Wikipedia

    en.wikipedia.org/wiki/Passive_sign_convention

    Illustration of the "reference directions" of the current (), voltage (), and power () variables used in the passive sign convention.If positive current is defined as flowing into the device terminal which is defined to be positive voltage, then positive power (big arrow) given by the equation = represents electric power flowing into the device, and negative power represents power flowing out.

  8. The Best High-Yield Dividend ETF to Invest $2,000 in Right Now

    www.aol.com/best-high-yield-dividend-etf...

    JEPQ data by YCharts.. Long-term dividend yields. The monthly payouts added up to $5.38 per share over the last year, or a 10.7% yield against the current share price of approximately $58.

  9. Equivalent circuit model for Li-ion cells - Wikipedia

    en.wikipedia.org/wiki/Equivalent_circuit_model...

    The equivalent-circuit model is used to simulate the voltage at the cell terminals when an electric current is applied to discharge or recharge it. The most common circuital representation consists of three elements in series: a variable voltage source, representing the open-circuit voltage (OCV) of the cell, a resistor representing ohmic internal resistance of the cell and a set of resistor ...