enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   These switches appear externally similar to single pole, single throw (SPST) switches, but have extra connections which allow a circuit to be controlled from multiple locations. Toggling the switch disconnects one "traveler" terminal and connects the other. Electrically, a typical "3-way" switch is a single pole, double throw (SPDT) switch. By ...

3. Distribution board - Wikipedia

   en.wikipedia.org/wiki/Distribution_board

   In a 96 dimmer rack, there are 32 dimmers on phase A, 32 dimmers on phase B, and 32 on phase C to spread out the lighting load as equally as possible. In addition to the power feed from the supply transformer in the building, a control cable from the lighting desk carries information to the dimmers in a control protocol such as DMX-512 .

4. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   Specific exceptions apply, such as a cable running to a switch and back (known as a traveler) where the white wire will be the hot wire feeding that switch. Another is for a cable used to feed an outlet for 250 VAC appliances that do not need a neutral, there the white is hot.

5. Electrical wiring - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring

   In North American practice, for residential and light commercial buildings fed with a single-phase split 120/240 service, an overhead cable from a transformer on a power pole is run to the service entrance point. The cable is a three conductor twisted "triplex" cable with a bare neutral and two insulated conductors, with no overall cable jacket ...

6. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   Dimmer in a residential application with RF-based remote control. Non domestic dimmers are usually controlled remotely by means of various protocols. Analogue dimmers usually require a separate wire for each channel of dimming carrying a voltage between 0 and 10 V. Some analogue circuitry then derives a control signal from this and the mains ...

7. Light switch - Wikipedia

   en.wikipedia.org/wiki/Light_switch

   Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]