enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Thor Power Tool Company - Wikipedia

   en.wikipedia.org/wiki/Thor_Power_Tool_Company

   By 1959, Thor Power Tool Company's annual volume had surpassed $30 million. [2] By the early sixties, Thor Power Tool Company was acquired by the Stewart-Warner Corporation. A short time later, Neil C. Hurley, Jr. died from a third heart attack, February 9, 1965, at the age of 54 and the Thor brand name almost died.

4. Power tool - Wikipedia

   en.wikipedia.org/wiki/Power_tool

   The cast metal housings were heavy, contributing to repetitive use injuries, as well as conductive – often shocking the user. As Henry Ford adapted to the manufacturing needs of World War II, he requested that A. H. Peterson, a tool manufacturer, create a lighter electric drill that was more portable for his assembly line workers. [20]

5. Automatic faucet - Wikipedia

   en.wikipedia.org/wiki/Automatic_faucet

   A hands-free faucet in Japan. An automatic faucet or tap (also hands-free faucet, touchless faucet, electronic faucet, motion-sensing faucet, sensor faucet, or infrared faucet) is a faucet equipped with a proximity sensor and mechanism that opens its valve to allow water to flow in response to the presence of a user's hands in close proximity.

6. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

7. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...