Search results
Results from the WOW.Com Content Network
A surface condenser is a water-cooled shell and tube heat exchanger installed to condense exhaust steam from a steam turbine in thermal power stations. [ 1 ] [ 2 ] [ 3 ] These condensers are heat exchangers which convert steam from its gaseous to its liquid state at a pressure below atmospheric pressure .
The steam which was used to turn the turbine is exhausted into the condenser and is condensed as it comes in contact with the tubes full of cool circulating water. The condensed steam, commonly referred to as condensate. is withdrawn from the bottom of the condenser. The adjacent image is a diagram of a typical surface condenser. [5] [6] [7] [8]
In nuclear power plants called pressurized water reactors, large heat exchangers called steam generators are two-phase, shell-and-tube heat exchangers which typically have U-tubes. They are used to boil water recycled from a surface condenser into steam to drive a turbine to produce power. Most shell-and-tube heat exchangers are either 1, 2, or ...
The condenser coil of a refrigerator. In systems involving heat transfer, a condenser is a heat exchanger used to condense a gaseous substance into a liquid state through cooling. In doing so, the latent heat is released by the substance and transferred to the surrounding environment. Condensers are used for efficient heat rejection in many ...
Figure 5 below displays a two-pass surface condenser. The pressure of steam at the turbine outlet is low where the steam density is very low where the flow rate is very high. To prevent a decrease in pressure in the movement of steam from the turbine to condenser, the condenser unit is placed underneath and connected to the turbine.
Unlike the surface condenser often used on a steam turbine or marine steam engine, the condensing apparatus on a steam locomotive does not normally increase the power output, rather it may decrease considerably due to a reduction of airflow to the firebox that heats the steam boiler. Condensing the steam from a high volume gas to a low volume ...
In 1838 Hall patented his "surface condenser", in which the steam is condensed by passing it through a number of small tubes cooled on the outside. It was chiefly intended for use at sea, and it was hoped that the difficulties attending the presence of salt in boilers would be obviated by charging them with fresh water at the start of a voyage ...
The rotors have a propeller-like arrangement of blades at the outer edge. Steam acts upon these blades, producing rotary motion. The stator consists of a similar, but fixed, series of blades that serve to redirect the steam flow onto the next rotor stage. A steam turbine often exhausts into a surface condenser that provides a vacuum. The stages ...