Search results
Results from the WOW.Com Content Network
Units were either written out in full, or abbreviated. Thus, five hours eighty three minutes decimal might be written as 5 h. 83 m. Even today, "h" is commonly used in France to separate hours and minutes of 24-hour time, instead of a colon, such as 14h00. Midnight was represented in civil records as "ten hours".
The proper procedure for converting hand times would be to round any hundredths up to the next higher even tenth of a second and then add the .24 to get a time for comparison purposes only. [1] But many meets displayed the converted marks accurate to the hundredth making the results look like they were taken with fully automatic timing.
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
1.67 minutes (or 1 minute 40 seconds) 10 3: kilosecond: 1 000: 16.7 minutes (or 16 minutes and 40 seconds) 10 6: megasecond: 1 000 000: 11.6 days (or 11 days, 13 hours, 46 minutes and 40 seconds) 10 9: gigasecond: 1 000 000 000: 31.7 years (or 31 years, 252 days, 1 hour, 46 minutes, 40 seconds, assuming that there are 7 leap years in the interval)
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
Many track and field statisticians use a conversion factor estimate of 0.24 seconds added to any hand-timed mark in the 100 m or 200 m event, and 0.14 seconds to any hand-timed mark in the 400 m or longer event: these conversion factors are only applicable for comparing marks from a variety of sources, and are not acceptable for record purposes.
In arithmetic, a hundredth is a single part of something that has been divided equally into a hundred parts. [1] For example, a hundredth of 675 is 6.75. In this manner it is used with the prefix "centi-" such as in centimeter.
In engineering and science, dimensional analysis is the analysis of the relationships between different physical quantities by identifying their base quantities (such as length, mass, time, and electric current) and units of measurement (such as metres and grams) and tracking these dimensions as calculations or comparisons are performed.