enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Some 2-hole punches have an "888" marking on their paper guide, to assist punching all four holes into A4 paper. [ 5 ] Konica Minolta specifies that for European 4-hole arrangements, all holes should be 11 ± 1 mm from the nearest (i.e. long/spine) edge of the paper, [ 6 ] which is slightly at variance with ISO 838's specification of 12 ± 1 mm .

3. Wheatstone system - Wikipedia

   en.wikipedia.org/wiki/Wheatstone_system

   The paper punches were labelled with numbers: 1 for the top hole of the dot, 2 for the sprocket hole for dot, and 3 for the bottom hole for dot. When a dash was punched, extra hole punches to the right punched a centre hole with number 4 and a bottom hole with number 5. [2] The perforator was introduced in 1867. [6]

4. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

5. Swingline - Wikipedia

   en.wikipedia.org/wiki/Swingline

   Swingline is a division of ACCO Brands Corporation that specializes in manufacturing staplers and hole punches. From its foundation in 1925, the company was located in Long Island City, Queens, New York, United States, until the plant was moved to Nogales, Mexico, in 1999. [1]

6. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   The distance from the punched holes to the nearest edge of the paper is less critical, since small differences do not affect the compatibility of paper and binder. Typical distance from the paper edge to the center of the hole is 0.5 inches (13 mm), and typical diameter of the hole ranges from 0.25 inches (6.4 mm) to 0.31 inches (7.9 mm) in ...

7. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch and die themselves can have a variety of shapes to create an array of different shaped holes in the workpiece. Multiple punches may be used together to create a part in one step. Usually, the punch and die are close to the same dimensions, creating a sheared edge when they meet.