Search results
Results from the WOW.Com Content Network
A Bunsen burner, named after Robert Bunsen, is a kind of ambient air gas burner used as laboratory equipment; it produces a single open gas flame, and is used for heating, sterilization, and combustion.
The Teclu burner vs. the Amal burner: The Amal burner is a burner created by the modification of the Bunsen and Teclu burner. The Amal burner was marketed by Messrs. Amal Ltd., of Birmingham. In this burner, a needle valve is inserted in the orifice of the jet to sensitively control the gas flow into the burner by an external screw.
In a Bunsen flame, a steady flow rate is provided which matches the flame speed so as to stabilize the flame. If the flow rate is below the flame speed, the flame will move upstream until the fuel is consumed or until it encounters a flame holder. If the flow rate is equal to the flame speed, we would expect a stationary flat flame front normal ...
Alcohol burners are preferred for some uses over Bunsen burners for safety purposes, and in laboratories where natural gas is not available. Their flame is limited to approximately 5 centimeters (two inches) in height, with a comparatively lower temperature than the gas flame of the Bunsen burner.
Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...
A variety of Bunsen burner flames. Bunsen burners may be adjusted from a highly luminous flame (left) to a hotter 'roaring blue flame' (right) One of the most familiar instances of a luminous flame is produced by a Bunsen burner. This burner has a controllable air supply and a constant gas jet: when the air supply is reduced, a highly luminous ...
If you've been having trouble with any of the connections or words in Saturday's puzzle, you're not alone and these hints should definitely help you out. Plus, I'll reveal the answers further down
It is used when laboratory work requires a hotter flame than one attainable using a Bunsen burner, or when a flame of larger diameter is desired, such as when working with inoculation loop needing sterilization or in some glassblowing operations. The burner was introduced by French chemist Georges Méker in an article published in 1905. [1]