Search results
Results from the WOW.Com Content Network
Port Harcourt – Onne, convertible sleepers installed since gauge conversion not imminent. 1,067 mm (3 ft 6 in) 750 mm (2 ft 5 + 1 ⁄ 2 in) 1915 Norway: Sulitjelma Line converted from 750 mm (2 ft 5 + 1 ⁄ 2 in) to dual gauge with 1,067 mm (3 ft 6 in) and when later closed was converted to a road. 1,435 mm (4 ft 8 + 1 ⁄ 2 in)
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
The move to s [1] teel shot reduced the use of 16 and 20 gauges for waterfowl hunting, and the shorter, 2 + 3 ⁄ 4-inch (70 mm), 12-gauge shells as well. However, the 3 + 1 ⁄ 2-inch (89 mm) 12-gauge shell, with its higher SAAMI pressure rating of 14,000 psi (97 MPa) compared to standard 2 + 3 ⁄ 4-inch (70 mm) and 3-inch (76 mm) 12-gauge ...
Length (system unit unit-code symbol or abbrev. notes sample default conversion combination output units SI: megametre: Mm Mm US spelling: megameter 1.0 Mm (620 mi) kilometre
Length; system unit code (other) symbol or abbrev. notes conversion factor/m combinations SI: gigametre: Gm Gm US spelling: gigameter 1.0 Gm (620,000 mi) megametre: Mm Mm US spelling: megameter
{{convert|100|Mm|mm}} → 100 megametres (1.0 × 10 11 mm) The output of {{convert}} can display multiple converted units, if further unit-codes are specified after the second unnamed parameter (without the pipe separator). Typical combination output units are listed below in column 7. {{convert|55|nmi|km mi}} → 55 nautical miles (102 km; 63 mi)
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length.
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.