enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   Aircraft plywood is available in thicknesses of 1 ⁄ 8 inch (3 mm) (3-ply construction) and upwards; typically aircraft plywood uses veneers of 0.5 mm (approx 1/64 in) thickness although much thinner veneers such as 0.1 mm are also used in construction of some of the thinner panels.

3. BS 1088 - Wikipedia

   en.wikipedia.org/wiki/BS_1088

   Face Veneer thickness-- For any three-ply construction, which applies to 3 and 4 mm material, each face veneer shall be not thinner than 1/8 of the total thickness of veneers assembled dry. Since the dry thicknesses of the boards are 3.6 and 4.6 respectively, we can assume that, for these thicknesses only, the face veneers will be as follows:

4. Engineered wood - Wikipedia

   en.wikipedia.org/wiki/Engineered_wood

   Plywood and OSB typically have a density of 560–640 kg/m 3 (35–40 lb/cu ft). For example, 9.5 mm (3 ⁄ 8 in) plywood sheathing or OSB sheathing typically has a surface density of 4.9–5.9 kg/m 2 (1–1.2 lb/sq ft). [51] Many other engineered woods have densities much higher than OSB.

5. Shear wall - Wikipedia

   en.wikipedia.org/wiki/Shear_wall

   A typical timber shear wall consists of braced panels in the wall line, constructed using structural plywood sheathing, specific nailing at the edges, and supporting framing. A shear wall is an element of a structurally engineered system that is designed to resist in-plane lateral forces, typically wind and seismic loads.

6. Oriented strand board - Wikipedia

   en.wikipedia.org/wiki/Oriented_strand_board

   The number of layers placed is determined partly by the thickness of the panel, but is limited by the equipment installed at the manufacturing site. Individual layers can also vary in thickness to give different finished panel thicknesses; typically, a 15 cm (5.9 in) layer will produce a 15 mm (0.59 in) panel thickness [citation needed]. The ...

7. Shiplap - Wikipedia

   en.wikipedia.org/wiki/Shiplap

   Exterior walls [ edit ] Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm ( 3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm ( 3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [ 1 ]