enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Solenoid valve - Wikipedia

   en.wikipedia.org/wiki/Solenoid_valve

   A solenoid valve is an ... an industrial 1 ⁄ 2-inch 10,000 psi valve, intended for 12, ... Solenoid valves are used in fluid power pneumatic and hydraulic ...

3. Solenoid (engineering) - Wikipedia

   en.wikipedia.org/wiki/Solenoid_(engineering)

   Hydraulic solenoid valves are in general similar to pneumatic solenoid valves except that they control the flow of hydraulic fluid (oil), often at around 3000 psi (210 bar, 21 MPa, 21 MN/m 2). Hydraulic machinery uses solenoids to control the flow of oil to rams or actuators. Solenoid-controlled valves are often used in irrigation systems ...

4. Electrohydraulic servo valve - Wikipedia

   en.wikipedia.org/wiki/Electrohydraulic_servo_valve

   A servo valve receives pressurized hydraulic fluid from a source, typically a hydraulic pump. It then transfers the fluid to a hydraulic cylinder in a closely controlled manner. Typically, the valve will move the spool proportionnaly to an electrical signal that it receives, indirectly controlling flow rate.

5. Variable force solenoid - Wikipedia

   en.wikipedia.org/wiki/Variable_force_solenoid

   A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.

6. Hydraulic manifold - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_manifold

   A manifold is composed of assorted hydraulic valves connected to each other. It is the various combinations of states of these valves that allow complex control behaviour in a manifold. [ 1 ] [ citation needed ] A hydraulic manifold is a block of metal with flow paths drilled through it, connecting various ports. [ 2 ]

7. Delay box - Wikipedia

   en.wikipedia.org/wiki/Delay_box

   As long as the race car driver holds the pushbutton depressed the delay box sends 12 Volts DC (or 16VDC) at many Amperes to the race car's transmission (where an internal electromagnetic solenoid located in or on the transmission energizes, which in turn positions a spool valve that directs hydraulic fluid pressure in the transmission valvebody ...