Ads
related to: 50 ohm microwave input box with timer and remote switch
Search results
Results from the WOW.Com Content Network
Like other electrical switches, RF and microwave switches provide different configurations for many different applications. Below is a list of typical switch configurations and usage: Single pole, double throw (SPDT or 1:2) switches route signals from one input to two output paths. Single pole double throw (SPDT) switch from Agilent Technologies
Monolithic microwave integrated circuit, or MMIC (sometimes pronounced "mimic"), is a type of integrated circuit (IC) device that operates at microwave frequencies (300 MHz to 300 GHz). These devices typically perform functions such as microwave mixing , power amplification, low-noise amplification , and high-frequency switching.
Mechanical Design: design of an electrically shielded enclosure or box, internal component mounting brackets, with a component and cabling layout. RF/Microwave Design: a signal routing and signal conditioning design and testing plan. A calibration plan for the switch matrix would need to be developed to properly characterize the signal paths.
In general a 50 ohm socket is not damaged by a 75 ohm pin, but the loose fit means the contact quality is not guaranteed; this can cause poor or intermittent operation, with the thin 75 ohm male pin only barely mating with the larger 50 ohm socket in the female. The 50 ohm type N connector is favored in microwave applications and microwave ...
Some manufacturers released some 4000-series equivalent CMOS circuits with a 74 prefix, for example, the 74HC4066 [2] was a replacement for the 4066 with slightly different electrical characteristics (different power-supply voltage ratings, higher frequency capabilities, lower "on" resistances in analog switches, etc.).
Directional couplers are frequently symmetrical so there also exists port 4, the isolated port. A portion of the power applied to port 2 will be coupled to port 4. However, the device is not normally used in this mode and port 4 is usually terminated with a matched load (typically 50 ohms). This termination can be internal to the device and ...
When input and output impedances are the same, voltage attenuation will be the square root of power attenuation, so, for example, a 6 dB attenuator that reduces power to one fourth will reduce the voltage (and the current) by half. Nominal impedance, for example 50 ohm; Frequency bandwidth, for example DC-18 GHz
The box needed to output radio frequency signals (compatible with a television's antenna input), composite video, and stereo audio. It had to include a remote control, and be compatible with universal remotes. The units had to support both a 4:3 center crop of a 16:9 transmitted image, and a letterboxed rendition of a 16:9 transmitted image.
Ads
related to: 50 ohm microwave input box with timer and remote switch