Search results
Results from the WOW.Com Content Network
The steering pivot points [clarification needed] are joined by a rigid bar called the tie rod, which can also be part of the steering mechanism, in the form of a rack and pinion for instance. With perfect Ackermann, at any angle of steering, the centre point of all of the circles traced by all wheels will lie at a common point.
A steering wheel (also called a driving wheel, a hand wheel, or simply wheel) is a type of steering control in vehicles. Steering wheels are used in most modern land vehicles, including all mass-production automobiles , buses, light and heavy trucks, as well as tractors and tanks .
A higher steering ratio means that the steering wheel is turned more to get the wheels turning, but it will be easier to turn the steering wheel. A lower steering ratio means that the steering wheel is turned less to get the wheels turning, but it will be harder to turn the steering wheel. Larger and heavier vehicles will often have a higher ...
Camber angle is one of the angles made by the wheels of a vehicle; specifically, it is the angle between the vertical axis of a wheel and the vertical axis of the vehicle when viewed from the front or rear. It is used in the creation of steering and suspension.
Depending on the driver, steering force and transmission of road forces back to the steering wheel and the steering ratio of turns of the steering wheel to turns of the road wheels affect control and awareness. Play—free rotation of the steering wheel before the wheels rotate—is a common problem, especially in older model and worn cars.
The steering linkage which connects the steering gearbox to the front wheels consists of a number of rods. These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the ...
When a wheel is set up to have some camber angle, the interaction between the tire and road surface causes the wheel to tend to want to roll in a curve, as if it were part of a conical surface (camber thrust). This tendency to turn increases the rolling resistance as well as increasing tire wear. A small degree of toe (toe-out for negative ...
As the rear wheels are fixed, this centre is on a line extended from the rear axle. This requires the inside front wheel to be turned further by the steering mechanism than the outside front. If the track rod is behind the axle, this is achieved by the steering arms from each hub pointing inwards to the rear, i.e. this is not a parallelogram.