Search results
Results from the WOW.Com Content Network
[2] The most common form of pile driver uses a heavy weight situated between vertical guides placed above a pile. The weight is raised by some motive power (which may include hydraulics, steam, diesel, electrical motor, or manual labor). At its apex the weight is released, impacting the pile and driving it into the ground. [1] [3]
Screw foundations first appeared in the 1800s as pile foundations for lighthouses, [4] and were extensively used for piers in harbours. Between the 1850s through 1890s, more than 100 screw-pile lighthouses were erected on the east coast of the United States using screw piles.
In jet piling high pressure water is used to set piles. [8] High pressure water cuts through soil with a high-pressure jet flow and allows the pile to be fitted. [9] One advantage of Jet Piling: the water jet lubricates the pile and softens the ground. [10] The method is in use in Norway. [11]
Franki piles can be used as high-capacity deep foundation elements without the necessity of excavation or dewatering. [4] They are useful in conditions where a sufficient bearing soil can only be reached deeper in the ground, [5] [6] and are best suited to granular soil where bearing is primarily achieved from the densification of the soil around the base. [4]
Pressure piling is a phenomenon related to combustion of gases in a tube or long vessel. When a flame front propagates along a tube, the unburned gases ahead of the front are compressed, and hence heated. The amount of compression varies depending on the geometry and can range from twice to eight times the initial pressure.
The suction caissons are in many cases easier to install than piles, which must be driven (hammered) into the ground with a pile driver. [4] Mooring lines are usually attached to the side of the suction caisson at the optimal load attachment point, which must be calculated for each caisson. Once installed, the caisson acts much like a short ...
Dynamic load testing (or dynamic loading) is a method to assess a pile's bearing capacity by applying a dynamic load to the pile head (a falling mass) while recording acceleration and strain on the pile head. Dynamic load testing is a high strain dynamic test which can be applied after pile installation for concrete piles. For steel or timber ...
The resolution of the CPT in delineating stratigraphic layers is related to the size of the cone tip, with typical cone tips having a cross-sectional area of either 10 or 15 cm 2, corresponding to diameters of 3.6 and 4.4 cm. A very early ultra-miniature 1 cm 2 subtraction penetrometer was developed and used on a US mobile ballistic missile ...