Search results
Results from the WOW.Com Content Network
The IP MTU and Ethernet maximum frame size are configured separately. In Ethernet switch configuration, MTU may refer to Ethernet maximum frame size. In Ethernet-based routers, MTU normally refers to the IP MTU. If jumbo frames are allowed in a network, the IP MTU should also be adjusted upwards to take advantage of this.
The default TCP Maximum Segment Size is for IPv4 is 536. For IPv6 it is 1220. [1]: §3.7.1 Where a host wishes to set the maximum segment size to a value other than the default, the maximum segment size is specified as a TCP option, initially in the TCP SYN packet during the TCP handshake. The value cannot be changed after the connection is ...
Path MTU Discovery (PMTUD) is a standardized technique in computer networking for determining the maximum transmission unit (MTU) size on the network path between two Internet Protocol (IP) hosts, usually with the goal of avoiding IP fragmentation.
TCP window scale option is needed for efficient transfer of data when the bandwidth-delay product (BDP) is greater than 64 KB [1].For instance, if a T1 transmission line of 1.5 Mbit/s was used over a satellite link with a 513 millisecond round-trip time (RTT), the bandwidth-delay product is ,, =, bits or about 96,187 bytes.
The option value is derived from the maximum transmission unit (MTU) size of the data link layer of the networks to which the sender and receiver are directly attached. TCP senders can use path MTU discovery to infer the minimum MTU along the network path between the sender and receiver, and use this to dynamically adjust the MSS to avoid IP ...
The frame size used by an end-to-end connection is typically limited by the lowest frame size in intermediate links. 802.5 Token Ring can support frames with a 4464-byte MTU, FDDI can transport 4352-byte, ATM 9180-byte and 802.11 can transport 7935-byte MTUs.
The limitation caused by window size can be calculated as follows: T h r o u g h p u t ≤ R W I N R T T {\displaystyle \mathrm {Throughput} \leq {\frac {\mathrm {RWIN} }{\mathrm {RTT} }}\,\!} where RWIN is the TCP Receive Window and RTT is the round-trip time for the path.
An example of the fragmentation of a protocol data unit in a given layer into smaller fragments. IP fragmentation is an Internet Protocol (IP) process that breaks packets into smaller pieces (fragments), so that the resulting pieces can pass through a link with a smaller maximum transmission unit (MTU) than the original packet size.