Search results
Results from the WOW.Com Content Network
The hoppus cubic foot (or ‘hoppus cube’ or ‘h cu ft’) was the standard volume measurement used for timber in the British Empire and countries in the British sphere of influence before the introduction of metric units. It is still used in the hardwood trade in some countries.
The IEEE symbol for the cubic foot per second is ft 3 /s. [1] The following other abbreviations are also sometimes used: ft 3 /sec; cu ft/s; cfs or CFS; cusec; second-feet; The flow or discharge of rivers, i.e., the volume of water passing a location per unit of time, is commonly expressed in units of cubic feet per second or cubic metres per second.
{{convert|123|cuyd|m3+board feet}} → 123 cubic yards (94 m 3; 40,000 board feet) The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked.
Yet other definitions are in use for industrial gas, [5] where, in the US, a standard cubic foot for industrial gas use is defined at 70 °F (21.1 °C) and 14.696 psia (101.325 kPa), while in Canada, a standard cubic meter for industrial gas use is defined at 15 °C (59 °F) and 101.325 kPa (14.696 psia).
See Weight for detail of mass/weight distinction and conversion. Avoirdupois is a system of mass based on a pound of 16 ounces, while Troy weight is the system of mass where 12 troy ounces equals one troy pound.
Standard cubic feet per minute (SCFM) is the molar flow rate of a gas expressed as a volumetric flow at a "standardized" temperature and pressure thus representing a fixed number of moles of gas regardless of composition and actual flow conditions.
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
The alttype field allows conversion between units of different type, provided each unit is whitelisted to allow the conversion. As at December 2013, the following energy units have alttype = "torque" (the first line consists of different units, while the second line consists of aliases for units in the first line):